Yealink T22P Multicast Paging

March 2017

OnSIP enables Multicast Paging automatically for every phone that supports it. A 'page' is a one-way announcement that can relay information to large groups of people quickly. Unlike an intercom or a phone call, Multicast Paging does not allow the listener to respond to the message.

When you use the OnSIP boot server for Polycom phones, there is a paging button easily accessible via your phone’s home screen. The button is ready to use as soon as the phone comes online. However, the Yealink phones that support Multicast Paging require a few additional steps after the phone has registered with our boot server.

Note: This article is intended to assist users in getting Multicast Paging up and running quickly. For an explanation of settings that are not discussed here, please see the User or Admin Guide for specific phone.

* Configure a multicast paging key (This is to SEND the page) via phone's web interface: 

  1. Enable 'Web Interface' in the OnSIP Admin Portal under Resources tab (locate MAC, enable web interface, save and then restart phone to pick up change).
  2. After entering your phone's IP address, Username = admin, Password = phone password (collected from Resources tab in OnSIP Admin Portal) -> Click on the DSSKey.
  3. In the desired Line select "Multicast Paging" from the Type dropdown menu.
  4. Enter the following multicast IP address and port number in the "Value" field = (Yealinks on the boot server will use this universal IP and port, not what is listed in the Yealink User Guide).
  5. Click "Confirm" to accept the changes. 
  6. There will not be a 'button' on your phone, you will simply have to know that whichever Line you just configured is the one you press (ie Line 2, press button 2 on your phone to send the page).


* Codec for Multicast Paging: 

  1. Click on the Features tab.
  2. Click General Information in the left of your screen.
  3. Scroll down to find Multicast Paging.
  4. Select the following Codec: G722 from dropdown.
  5. Click "Confirm" to accept the changes.


* Receive the Multicast Page

In order to receive the multicast page, the following must be done.

  1. Click on the Directory tab.
  2. Click MulticastIP in the left of your screen.
  3. Make certain Paging Barge is '10' and Paging Priority Active is Enabled.
  4. Enter the 'Listening Address' and port number as done above ->
  5. Enter the label in the Label field.  In the example we simply called it "Page All".
  6. Click "Confirm" to accept the changes. 



See our top business VoIP phone recommendations for 2017

Download the 2017 Business Phone Guide

Was this article helpful?
0 out of 0 found this helpful