This device must be manually configured. Do not add MAC Address to Resources.
The information below is based on the Converge Pro2, 128V, firmware 126.96.36.199
Step 1: Gather information for each user
Each user has a set of credentials which will be needed to configure each device. For each device that you are configuring, obtain the following:
- "SIP Address" (Address of Record)
- "SIP Password"
- "Auth Username"
- "Outbound Proxy"
You can find this information in the OnSIP Admin Portal, "User" tab, click on User's name the device will be configured to expand boxes, "Phone Configuration" box:
Step 2: Log into your device through a web browser
The default login is admin/admin
Step 3: Enter your user information from Step 1
Control Panel ->Stack ->Equipment ->VoIP tab ->VoIP/SIP
- Configure VoIP for: VoIP/SIP
- Send VoIP Traffic to: Ethernet Port
VoIP tab ->VoIP/SIP ->Proxy 1 tab:
- TCP Port > 5060
- UDP Port > 5060
- User Domain > Proxy / Domain
- Registar Address > Proxy / Domain
- Registar Port > 5060
- Outound Proxy Address >sip.onsip.com
- Outbound Proxy Port > 5060
- Transport Type > UDP
Equipment ->IP-Phone ->VoIP Phones ->Phone 1:
- Phone Number -> Username
- Name / Label -> Whatever you'd like
- User Name ->Auth Username
- Password -> SIP Password
Step 4: Confirm that your device is registered
In the Admin Portal, click on the "Users" tab. You will see a green "online" notation next to each user with a registered device.
Assistance outside of registering the device to OnSIP should be directed to the manufacturer.
Added July 2018